What about Windows 8?

When I connect the MCS6 / MCS6A / MPA4(T) to a Windows 7 PC, the PC somehow doesn't ask or install its driver. Isn't the MCS6 also working on Windows 7?

Would it be possible to run more than two of your P7888 Cards on a single PC in order to have more than 8 input channels? Is the total transfer rate for ALL boards (summed > together) still (about) 20 MHz?

Please could you let me know if there are any known incompatibilities between P7889 and this DELL workstation I intend to buy? Please could you also let me know if Windows 7 64bit is supported by your drivers, or whether I will need to install a 32bit OS?

Is there anyway to save the P7887 data from each scan using the calibration variable (say, time of flight) instead of the bin number?

Is there in fact any more documentation on using the DDE method, in addition to what I have referenced below in the manual?

Can P7888 be controlled by Matlab?

The measurement is stopped with acquisition times of multiples of 2 seconds when using my P7888-1E and time preset mode using DMA. Where does it come from?

How can we access via DLL the data stream of P7889 count events ?

I use fast position-dependent detectors with delay-line read out. The maximum count rate that I can reach using two 7072T TDC's in coincidence and MPA-3 is only about 350 kHz per input. Is there a solution that can handle a higher count rate?

Is it possible to have two P7888-2 cards working as if it were a four-channel one?

Is there for the Ultra Fast Multiscalers the FAST ComTec three-year-warranty included?